![]() Flashing Red: (only applies to P-SKU’s) Filter is installed backward or an issue with the NFC board in the water fountain or tag on the filter.The filter has reached 100% of its life or been in use for 12 months.These are the meanings of the different filter colors Then open the case of the water fountain and use a screw driver or a edged tipped object such as a swiss knife blade to adjust the water stream.Ĭheck this too: Fleck Water Softener How to and Troubleshooting Guide Filter Status LED Lights Explained Locate the water stream adjuster on the user manual. Remove the insulation from the line and remove the kink. The regulator valve is defective or restricted with debris.Ī flexible water line is kinked within the water cooler. The water shut-off valve is not open all of the way. The regulator screw is turned clockwise, and the water flow i s still too low. The water cooler has an added filter that is restricted. The strainer screen is plugged with debris. The solenoid will not open up all the way on EZ, HTV, or electronic eye models. Refer to the manual and adjust press bar adjustment screw. The press bar adjustment screw has not been adjusted for EHF, WC, HAC, or EMABF series water coolers. Remove sealant and use Teflon tape or compression fitting. Water pressure is lower than factor test conditions. Stream is too low after the initial installation of the product. (similar to placing your thumb partially over the end of the garden hose). Shut off valve is not open all the way, causing backpressure.īubbler or orifice is partially restricted with mineral deposits causing back pressure Refer to the manual and adjust regulator screw counter-clockwise to the desired height. Water pressure is higher than factory test conditions. Then replace the top cover of the water fountain.The reset is complete once the filter status light turns green.When the following message ‘RST FLTR’ appears on the screen, press the black reset button on the top right side of the LED bottle filler counter.Different messages will flash across the LED interface.Then press the black reset button located on the top right side and hold it for at least two seconds before releasing.Remove the top cover of your ezH2O water fountain.Contact service agent.įollow these steps to reset your water fountain if it has an LED bottle filler counter. The compressor is making a loud knocking or grinding noise. Locate correct terminal and plug into cold control.Ĭompressor or inside of water cooler is hot. Wire terminal not plugged into cold control. The compressor is room temperature and the fan will not run. Remove debris with compressed air or vacuum (may have caused overload, relay, or compressor defect) The compressor needs to be replaced contact service agent. Remove debris with compressed air or vacuum (may have caused overload, relay, or compressor defect). The relay connection to the compressor is loose.Ĭondenser fins in front of the fan are covered with debris. The compressor is warm or hot and the fan will not shut off.
0 Comments
Leave a Reply. |